Filter
Top Products
3Mt Tattle-Tapet Security Strips
3M Library Security System
5-8
E 3M 1999 September
5.4 Compact Disc Protection —
3Mt
tt
t Tattle-Tapet
tt
t Security Overlay:
DCD-2
Description/Characteristics
The 3Mt Tattle-Tapet DCD-2 Compact Disc
Security Overlay is designed to be applied directly on
CDs and CD-ROMs. The security strip and overlay
are combined to simplify i nstallation.
Once applied, protection and full circulation of CDs
and CD-ROMs is provided for life of the marked item.
Security strips on protected compact discs must be
properly desensitized so the compact discs can be
carried through the detection system without causing
an alarm.
Security Strip Application
The 3M Tattle-Tape DCD-2 overlay should be applied
and stored away from areas which are readily
accessible t o patrons.
DCD-2 overlays should be applied only t o surfaces
which are flat, clean, dry and at room temperature. For
maximum adhesion, minimize touching the adhesive
surface of the overlay.
Marking Compact Discs
1. Place the security strip/overlay on the label side of
the compact disc.
2. Center the security overlay on the compact disc
and hold it firmly in position.
3. Lift the smaller portion of the overlay and bend it
back while removing the liner, rolling the
adhesive surface of the overlay onto the CD
surface.
4. Remove the liner from the large portion of the
overlay
— as in step 3 — securing it to the CD
surface.
5. Rub the entire surface of the overlay to securely
bond it to the CD.
Note: Allow 24 hours for maximum adhesion of
overlay to CD.