Filter
Top Products
3M Library Security SystemSystem Configuration
3-12
E 3M 1999 September
3.13 Turning Your System On
The 3Mt Detection System Model 3501/3502 is
designed to be left on continuously.
To turn on, connect the Electronics Enclosure power
cord to a power outlet. Turn the On/Off key switch to
ON. The Power On indicator light should be on.
Allow 15 seconds for the system to start up.
3.14 How to Verify System Operation
Your 3Mt Detection System Model 3501/3502
should be inspected daily for proper operation.
Proper system operation is indicated when the red
power indicator light is illuminated. System operation
may be verified by passing through the system with a
marked book, which should result in an audible alarm
and a light on at the top of the panels. Each pass
through the system should also increment the counter
by one. The alarm/inhibit light on the Electronics
Enclosure should also be illuminated (green) at the
time of alarm. If the system does not respond, see the
Troubleshooting Guide in Section 6.
There i s no need for r epetitive walk-through testing.