Filter
Top Products
2 Getting Started
Up and Running overview
Getting Started
Up and Running overview
2. Place the QUESTempº 34 & 36 in the work area in a safe location
approximately 3.5 feet off the ground.
3. Power On the QUESTempº34 & 36 and check the battery.
• If the battery voltage displayed during the power-on sequence is less than or
equal to 6.4 volts, replace or recharge the batteries.
5. In the main menu, View will be selected (an indicator arrow denotes the
selected menu). Press the I/O Enter key to select.
7. Use the Up/Down Arrow keys to set the display to the desired items.
Getting started
1. Make sure the wet bulb wick is clean. Fill reservoir with distilled water.
•
See “check wick and fill natural wet bulb”, pg 5.
4. Be aware that the sensors require 10 minutes to stabilize to a new
environment.
6. Press the Run/Stop key to begin storing data.