Filter
Top Products
Printing
Serial
14
Printing
The recorded data can be sent to a computer through the serial RS-232 port or to a
parallel printer. Serial transmission requires 3M cable #54-715. Parallel
transmission requires 3M cable #56-875. With the cable plugged into the RS-232
auxiliary port, select Print from the menu and press the I/O Enter key to enter the
Print mode. Begin printing by pressing the I/O Enter key. Press the key again to
abort printing.
Serial
DMS software is recommended for downloading, storing, and graphing your data.
Communications programs such as Window’s HyperTerminal may also be used to
capture the printout into a file. The baud rate is fixed at 9600.
Parallel
Data can be sent directly to parallel printers that accept direct ASCII test input
without special drivers. Make sure the printer is powered on and is online, ready
to accept data, prior to printing.
Figure 1-19: Sample printout (page 1)
3M Page 1
HEAT STRESS REPORT
File Name _________________________ Questemp 36 Rev 1.00
Serial # TK09090909
Employee _________________________
Facility _________________________ Session (3)
Start: 21-FEB-08 11:07:32
Department _________________________ Stop: 21-FEB-08 11:10:15
Job _________________________ Printed: 21-FEB-08 11:16:00
Comments/Notes______________________________________________
____________________________________________________________
Logging Interval: 1 minutes
Degrees Fahrenheit
MAXIMUM LEVELS, Sensor 1
WBGT IN 69.2 21-FEB-08 11:10:14
WBGT OUT 68.3 21-FEB-08 11:10:08
WET BULB 59.7 21-FEB-08 11:10:08
DRY BULB 82.7 21-FEB-08 11:09:56
GLOBE 91.4 21-FEB-08 11:10:12
HEAT INDEX 0 00-XXX-00 00:00:00
REL HUMIDITY 14% 21-FEB-08 11:07:32
FLOW (m/s) 0.6 21-FEB-08 11:09:08
MAXIMUM LEVELS, Sensor 2
WBGT IN 81.2 21-FEB-08 11:10:06
WBGT OUT 80.5 21-FEB-08 11:10:11
WET BULB 70.5 21-FEB-08 11:10:11
DRY BULB 99.2 21-FEB-08 11:09:07
GLOBE 106 1 21 FEB 08 11:10:06
Printing