Filter
Top Products
Displayed Items
Run
11
Run
The run mode begins a session in memory and logs the data.
1. Begin a session by pressing the Run/Stop key from the view mode (or
measurement view). An asterisk in the lower right corner indicates the run
mode.
To toggle through the views, press the up or down arrow.
Figure 1-8: Run mode indicator
2. End the session by pressing the Run/Stop key again. (The session will stop
recording when the asterisk is no longer displayed.)
NOTE: If the logging memory is full or if there are no sensors plugged into the
unit, attempting to enter the Run mode will result in an error message. If the
memory capacity is exceeded, the asterisk in the lower right corner of the display
will turn into an “F” and the memory remaining screen will show “0.0”.
Displayed Items
For the QUESTemp° 34 & 36 models, the number in the upper right corner
indicates which sensor bar’s data is displayed.
• “1”indicates the sensor bar placed on (or attached to) the top of the
instrument. Sensors 2 and 3 are labeled on the side of the unit as “Sensor
2”, and “Sensor 3”.
• “W” indicates the weighted average which only appears if a WBGT is
displayed and all three sensor bars are attached. An asterisk in the lower
right corner indicates that the unit is in the run mode and is logging data.
The following measurements can be accessed on the display:
Screen 1: WET (Wet bulb)
DRY (Dry bulb)
Figure 1-9 Wet and Dry screen
WET 80.5º F 1
DRY 92.2º F
WBGTi 66.7º F 1
WBGTo 68.6º F
Run indicator
Displayed
items