When to Use SelecType
In general, use SelecType only for settings you cannot make in
your software, including the following:
❑
Changing the emulation modes and selecting the IES
(Intelligent Emulation Switching) mode
❑
Specifying the channel and configuring the interface
❑
Choosing the size of the memory buffer used to receive data
You should keep in mind the following points when using
SelecType settings:
❑
A number of SelecType settings can also be made using the
OneTouch modes, printer driver, and Remote Control
Panel utility.
❑
Application programs may send commands to the printer
that override SelecType settings. If you are not getting the
results you expect, check your application software settings.
❑
To see the current SelecType settings, print a status sheet.
❑
A map of all available SelecType menus is included in
Appendix E.
L
Albatross Rev. c
A5 size Chapter 5
96/08/23 Pass 0, DR
5-2
SelecType
