Your printer has the ability to emulate the following printers depending
on the printer emulation mode:
LJ-4 Hewlett-Packard LaserJet 4 (PCL5e)
ESC/P 2 EPSON LQ-570 (24-pin)
FX EPSON FX-870/1170, or LX-100 (9-pin)
GL/2 Hewlett-Packard GL/2 graphics language
In addition, the following printer control languages are supported:
PJL Printer Job Language
EJL EPSON Job Control Language
This appendix lists the printer commands for these modes. Most of the
commands closely emulate the original printer or the control language;
however, some have operational differences because the printers use
different technologies. Additional information is provided in the
descriptions of control commands with these differences.
For more information on emulation modes, refer to the following sections:
Changing the emulation mode Chapter 5
Available symbol sets or character tables Appendix B
Using the printer as an ESC/P 2 printer Chapter 5
Using the printer as an FX printer Chapter 5
Using the printer as a GL/2 plotter Chapter 5
L
Albatross Rev.c
A5 size Appendix C
96/08/23 pass 0
C-2
Command Summary
