❏ Be careful not to touch the fuser, which is marked CAUTION
Hot Surface Avoid Contact. If the printer has been in use, the
fuser can be very hot.
❏ Avoid touching the components inside the printer unless
instructed to do so in this guide.
❏ Never force the printer’s components into place. Although the
printer is designed to be sturdy, rough handling can damage it.
❏ Be sure not to scratch the surface of the drum. When you
remove the imaging cartridge from the printer, always set the
unit on a clean, smooth surface. Also, avoid touching the
drum, since oils from your skin can permanently damage its
surface and may affect print quality.
❏ Do not turn the cartridge upside down or stand it on its sides.
CAUTION Hot Surface Avoid Contact
rg-3
R
Albatross Rev.c
Reference Guide
A5 size Introduction
’96/08/23 pass 0
Getting Started
13
