44 Configuring the PowerConnect 3324/3348 Switch
www.dell.com | support.dell.com
Switching Port Default Settings
The following table describes the Port default settings.
Port Default Settings
The following is an example for changing the port speed on port 1/e5 using CLI
commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# speed 100
The following is an example for enabling flow control on port 1/e5 using CLI commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# flowcontrol on
The following is an example for enabling back pressure on port 1/e5 using CLI commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# back-pressure
Function Default Setting
Port speed and mode 10/100M copper ports: auto-negotiation
1000M auto-negotiation
Port forwarding state Enabled
Port tagging No tagging
Head of line blocking prevention On (Enabled)
Flow Control Off
Back Pressure Off
