Filter
Top Products
21
Installation instructions
General information
The YLCC water chillers and heat pumps are factory-charged
and tested packaged units.
Inspection
Upon reception, inspect the goods and notify the carrier and
the insurance company, in writing, of any possible damage
during transportation.
Environmental protection
Packing
Packing is made of recyclable material. Its elimination should
be carried out in accordance with local regulations on selec-
tive collection of residual material.
Elimination of the unit
Upon disassembly of the unit after a long service life, the
components should be recuperated ecologically. The cooling
circuit is full of refrigerant, which should be recuperated and
returned to the gas manufacturer for recycling.
Oil will remain in the hermetic compressor and, therefore,
must be returned with its circuit sealed.
The air conditioning unit will be deposited in an area deter-
mined by the local authorities, for its selective recuperation.
Warning signs
The following signs indicate the existence of potentially dan-
gerous conditions for users or servicing personnel.
Whenever found on the unit itself, take the meaning of each
one into account.
This symbol indicates an electrical danger
or risk.
Attention: It is obligatory to read the in-
structions prior to any handling.
Attention: Fan in operation.
Attention: Do not touch hot surfaces.
Attention: The unit is equipped with re-
mote control and can start automati-
cally. Two minutes prior to having ac-
cess to the interior, disconnect the
power supply so as to avoid any con-
tact with the fan turbine in motion.
Attention: Lifting point.
Transportation
The units should always be transported in vertical position
so as to avoid oil leaking out of the compressor. If, for any
reason, this position need be changed sporadically, they will
remain in that position a strictly necessary period of time only.
To move the units to their final location, the four rectangular
openings in the bed frame can be used with a forklift truck, or
the four cylindrical holes at the ends of the bed frame for
elevation.
YLCC
YLCC-H