Filter
Top Products
34
etc. is displayed, and press
RUN
PRGM
to begin
the factory preset program. Or you may
reprogram the thermostat, then replace it
on the wall.
To prevent further static discharge prob-
lems, touch another object to release static
build-up before touching the thermostat.
See OPERATING YOUR THERMOSTAT.
6. Why won’t the setpoint temperature go
to the temperature I want?
The highest heating setpoint temperature
you select must be at least 1°F lower than
the lowest cooling setpoint temperature
you select (for example, if 70°F is your
lowest selected cooling temperature, you
cannot select a heating temperature any
higher than 68°F). If such a conflict exists,
you must set the lowest cooling tempera-
ture higher in order to set the heating
temperature higher. To set a lower cooling
temperature, you must select a lower heat-
ing temperature. See PROGRAMMING
YOUR THERMOSTAT.
7. Why doesn’t the display light come on
when I press a button? Why don’t I hear
a beep when I press a button?
The display light and audio prompting
(beep) only work when the thermostat is on
the wall and 24VAC power is present to the
thermostat. These features will not work on
battery power alone. See OPERATING
YOUR THERMOSTAT.