Filter
Top Products
19
b. What temperature should the building be
at this time? (heating? cooling?)
2a. What time does the building become va-
cant?
b. What temperature should the building be
at this time?
Now look at the factory preprogrammed times
and temperatures shown below. If this program
will suit your needs, simply press
RUN
PRGM
to begin
running the factory preset program.
If you want to change the preprogrammed
times and temperatures, do the following.
Determine the heating and cooling times and
temperatures you want to use. Use the follow-
ing table to plan your program time periods and
temperatures. You may also want to look at the
sample program table to get an idea of how the
thermostat can be programmed. You may se-
lect up to two heating temperatures (HEAT O
for occupied temperature and HEAT U for
unoccupied temperature), and up to two cool-
ing temperatures (COOL O and COOL U).
To operate properly in the AUTO mode, there
must be a minimum 1°F separation between
the highest heat temperature and the lowest
cool temperature.
Heating Program for ALL days of the Week:
PERIOD TIME TEMP
Occupied (O)
Unoccupied (U)
8:00 AM
5:00 PM
70
64
FAN
PRG
AUTO
DAMPER
Open
Closed
FACTORY PREPROGRAMMING
Cooling Program for ALL days of the Week:
PERIOD TIME TEMP
Occupied (O)
Unoccupied (U)
8:00 AM
5:00 PM
78
82
FAN
PRG
AUTO
DAMPER
Open
Closed
NOTE