Filter
Top Products
Using the exhaust control
(on some models)
l To circulate room air (Figure 4) set Exhaust Control to
CLOSED. This setting allows continuous cooling.
l To exhaust stale/smoky air set Exhaust Control
to OPEN.
Exhaust control tips
. For maximum cooling efficiency, set the Exhaust Control
to CLOSED.
l The Exhaust Control will only function when the System
or Fan Control is turned to an “on” setting.
Changing air direction
The louvers in the top of the front panel allow you to control
the direction of the cooled air. Use the tabs to direct the air
up, down, right, left, or straight ahead. See Figure 5.
Using the ENERGY SAVER
settings
(on some models)
The ENERGY SAVER settings are the 3 settings at the
bottom of the System Control (HI, MED, and LO). These
settings save energy. The fan will cycle on and off as the
Thermostat Control turns the compressor on and off. This
saves the cost of electrical energy that would be used to
run the fan continuously.
It is normal for the fan to turn on and off in the ENERGY
SAVER settings. The amount of time the unit will be off
depends on the room temperature and Thermostat Control
setting.
10