Filter
Top Products
36
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Trolley Operator
HEADER
OPERATOR
FRAMING MEMBERS
PERFERATED ANGLE
OPERATOR
RAIL
PERFERATED
ANGLE
OPERATOR RAIL
SUITABLE
MOUNTING
SURFACE (2 X 6)
LUMBER MIN.
DOOR ARM TO OPERATOR
BRACKET
Operator must be tested at time of
installation and monthly there after to
ensure that door reverses on contact
with 2 X 4 board laid flat under the
door. Failure to pass this test requires
immediate adjustments or repairs.
FAILURE TO MAKE ADJUSTMENTS
OR REPAIRS, IF NECESSARY, CAN
RESULT IN SEVERE OR FATAL
INJURY.
If your operator is equipped with a
photoelectric eye system, then this must
be tested at the same time to ensure
that door does not close and a closing
door opens if photoelectric eye system
is obstructed. Failure to pass this test
requires immediate adjustments or
repairs.
FAILURE TO MAKE ADJUSTMENTS,
IF NECESSARY, CAN RESULT IN
SEVERE OR FATAL INJURY.
1. Install operator rail 1/2” to 1-1/2”
(13 - 38 mm) above high arc of top
section of the door.
2. Mount operator to ceiling so that
1” to 1-1/2” (25 - 38 mm)
clearance is maintained between
trolley rail and top section when
door is fully open (trolley rail will
slope down towards rear).
3. Attach door arm to operator bracket
installed in Step 9.
4. Attach operator rail to suitable
mounting surface, 2 x 6 lumber
minimum.
5. Attach operator to ceiling using
perforated angle.
IMPORTANT! ANGLES MUST BE
SECURELY ATTACHED TO SOUND
FRAMING MEMBER(S).
WARNING
WARNING