Filter
Top Products
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Tools Needed:
Drums
None
BOTTOM
SECTION
ASTRAGEL
5
IMPORTANT: RIGHT AND LEFT HAND IS
ALWAYS DETERMINED FROM INSIDE THE
GARAGE LOOKING OUT.
NOTE: For door section identification see
page 4.
TorqueMaster
®
counterbalance drums
are marked right and left hand. Uncoil
the counterbalance cables and make
sure you place the right hand cable loop
on the right hand milford pin and place
the left hand cable loop on the left hand
milford pin. Insert a roller into bottom
bracket of the bottom section and insert
another roller at #1 end hinge at the top
of the bottom section. Repeat for other
side.
NOTE: Verify astragal (bottom seal)
is aligned with door section. If there
is more than 1/2” excess astragal on
either side, trim astragal even with door
section.
4
BOTTOM SECTION
MILFORD PIN
ROLLERS
#1 END HINGE
(HINGE TUBE)
BOTTOM BRACKET
BOTTOM SECTION
LEFT HAND
COUNTERBALANCE
DRUM
Bottom Section
Before installing the bottom section,
the weather seal (may not be included)
must be installed (see PREPARING THE
OPENING on page 10)
Center the bottom section in the door
opening. Level section using wooden
shims (if necessary) under the bottom
section.
Level
BOTTOM
SECTION
DOOR OPENING
WEATHER SEAL
WOODEN SHIMS
(IF NECESSARY)
LEVEL