Filter
Top Products
3
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Package Contents
NOTE: DEPENDING ON THE DOOR MODEL, SOME PARTS LISTED
WILL NOT BE SUPPLIED IF NOT NECESSARY. REAR SUPPORTS
MAY OR MAY NOT BE INCLUDED WITH YOUR DOOR.
(1)TORQUEMASTER
®
SPRING TUBE
DOOR SECTIONS (AS REQUIRED)
ROLLERS
(AS REQUIRED)
(1) CENTER BRACKET
ASSEMBLY
COUNTER COVER(S)
(AS REQUIRED)
IDRIVE
®
OPERATOR
(SOLD SEPERATELY)
(1) LOOSE WINDING SHAFT
(SINGLE SPRING ONLY)
RIGHT & LEFT
DRUM WRAPS
SCREW EYE & PULL
ROPE (IF INCLUDED)
(1) OPERATOR BRACKET
LUBRICATING OIL
(AS REQUIRED)
(2) TOP BRACKET
BASES
COUNTER GEAR(S)
(AS REQUIRED)
RIGHT AND LEFT CABLE
DRUM ASSEMBLIES
© Copyright 2006 Wayne-Dalton Corp. Part No. 326538 NEW 06/22/2006
TorqueMaster
®
- Single and Double Spring(s)
Installation Instructions and Owner’s Manual
Portland Source Plant
IMPORTANT NOTICE!
Read these instructions carefully before
attempting installation. If in question about
any of the procedures, do not perform the
work. Instead, have a qualified door agency
do the installation or repairs.
9700 Series
MANUAL
RIGHT & LEFT
END BRACKETS
DRIVE GEAR(S)
(AS REQUIRED)
WEATHER SEAL & NAILS
(IF INCLUDED)
(2) TOP BRACKET
SLIDES
(2) HORIZONTAL TRACK WITH ATTACHED HORIZONTAL ANGLE RH/LH
(2) VERTICAL
RH/LH TRACK
(2) FULLY ADJUSTABLE
RH/LH FLAGANGLES
(2) 3/8”- 16 X 3/4”
HEX HEAD BOLTS
1/4”- 20 X 5/8” CARRIAGE
BOLTS (AS REQUIRED)
1/4”- 20 FLANGED HEX
NUTS (AS REQUIRED)
(2) 3/8”- 16 HEX
NUTS
JAMB BRACKETS
(AS REQUIRED)
U-BAR
(IF INCLUDED)
1/4”-14 X 5/8” SELF TAPPING
SCREWS (AS REQUIRED)
5/16” X 2” HEX HEAD LAG SCREWS (AS REQUIRED)1/4”-20 X 7/8” SELF DRILLING
SCREWS (AS REQUIRED)
(2) #10 PHILLIPS
HEAD SCREWS