Filter
Top Products
8
Waterford TARA T25 Direct Vent Freestanding Gas Stove
INSTALLATION
9) Connect the red wire from the thermodisc to the red wire of
the speed control wire harness.
10)Connect the live black wire from power cord to the black wire
of the speed control wire harness.
12)Ensure all wires are pulled away from firebox to avoid excessive
heat and secure with stick-on wire clip.
13)Re-attach rear access panel with 6 screws, reversing step 7.
NOTE: Pull excess wire next to fan to avoid excessive heat
from the firebox.
11)Slide the thermodisc into the bracket clip on the underside of the
firebox.
NOTE: When power cord is plugged in, speed control is in the
ON position and stove is burning, allow 10 - 15 minutes for
the thermodisc (temperature switch) to activate and turn on
the Fan automatically.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from
this plug.