Filter
Top Products
Waterford TARA T25 Direct Vent Freestanding Gas Stove
11
INSTALLATION
RESIDENTIAL AND MANUFACTURED HOMES / MOBILE HOMES
MINIUMUM HORIZONTAL TERMINATION INSTALLATIONS
You will require the following components with your new Regency Rear Vent Direct Vent
Freestanding Gas Stove. Please review your product to make sure you have everything you need.
In the event that you are missing any part, contact your dealer.
Decorative brass or chrome trim kits are available from Simpson
Dura-Vent for their wall thimbles, as well as a square
wall thimble cover.
Planning Your venting Installation
See page 9 for Exterior Vent Termination
requirements. The T25 is approved for a
minimum horizontal termination with the Regen-
cy Riser Vent Kit. See the diagram for minimum
and maximum pipe lengths.
When planning your installation, it will be nec-
essary to select the proper length of vent pipe
for your particular requirements. Determine the
minimum clearance to combustibles from the
rear of the unit to the wall. It is also important to
note the wall thickness. Before cutting the vent
hole through the wall ensure that ALL vent and
termination clearances (see page 10) will be
met.
The venting arrangements shown on the dia-
gram, have a minimum of 75% (flue loss)
efficiency with Fan Off, as required for man-
ufactured homes. (Actual efficiency may be as
high as 85%.)
*If this is an outside corner, the minimum dis-
tance between the vent and the outside corner
is 6" (15cm). See "F" on the diagram on page 10.
NOTE: Ensure compliance with the outside vent
terminal location before cutting hole as both
dimensions must be met.
Note: These are the minimum pieces re-
quired. Other parts may be required
for your particular installation.
Minimum components for a Horizontal Installation:
640-944 Horizontal Termination Kit which includes:
1 946-201 6-5/8" Dia. x 18" Black Pipe
1 946-207 4" Dia. x 18" Aluminum Vent
1 946-202 Wall Penetration Heat Shield (Wall Thimble) (2 pcs)
1 640-530 Riser Vent Terminal
1 640-545 Decorative Wall Trim (Black)
1 948-128 Tube Mill-Pac
Screws
945G* 1 45
o
Elbow
946-219 1 Adapter
Optional Components:
946-204 45
o
Elbow - 6-5/8" Black pipe
and 4" Aluminum Vent
946-205 Vinyl Siding Shield for Riser Vent
Terminal
946-208/P Vent Guard
940 Square Wall Thimble Cover*
981 Snorkel Termination (36")*
982 Snorkel Termination (14")*
942 Wall Penetration
Heat Shield*
* Simpson Dura-Vent components