Filter
Top Products
VIVOTEK
16 - User's Manual
Ceiling Mount Installation
Hole marked as D+
D
D
To attach the camera to AM-51A
mounting adaptor,
1. Remove the camera's top cov-
er.
2. Fasten 2 included screws to the
D holes (not the D+ hole).
3. Route cables through the
adapter.
4. Align the camera with the
mounting adapter and let the
2 screws enter the key holes
located on the sides where the
camera's cabling interfaces
reside, e.g., the Ethernet port.
5. Rotate the camera counter-
clockwise. You can then see
the D+ hole through the slotted
screw hole (in front of the Micro
SD slot).
6. Fasten screws to secure the
camera to the mounting adapt-
er.
473 mm
1
178 mm
47mm
AM-117
AM-51A
AM-114
Attach Camera to Mounting Adapter
Install the Pendant Pipe
Below is a sample procedure
using a pendant pipe:
1. Determine a hard surface ceil-
ing location, and use the four
mounting holes on the pendant
head to mark the positions
where holes will be drilled to
secure the pendant head. Note
that screws are user-supplied
and they should be at least
11mm long.
2. Route cables through the pen-
dant pipe and the pendant
head.
IMPORTANT:
Refer to the "Panoramic PTZ Installation Guide" in your product CD for design considerations
before you proceed with physical installation.