Filter
Top Products
23MUA-PRC001-EN
Dimension and
Weights
Table DW-5
Model A B C E F G H L M R S T
109 3' 0" 4' 4" 6' 5" 10-
3/8
" 1' 3-
1/8
" 1' 2-
7/16
"11-
11/16
" 1' 2-½" 11-
15/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (264) (384) (367) (297) (368) (303) (533) (838) (737)
112 3' 0" 4' 4" 6' 5" 1' 1-
9/16
"1' 1-
9/16
"1' 2-
7/16
"11-
11/16
" 1' 0-
5/8
"1' 3-
15/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (344) (344) (367) (297) (321) (405) (533) (838) (737)
115 3' 0" 4' 4" 6' 5" 1' 4" 1' 0-
3/8
" 1' 7-
7/8
"6-
15/16
"11-
1/8
" 1' 6-
15/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (406) (314) (505) (176) (283) (481) (533) (838) (737)
118 3' 0" 4' 4" 6' 5" 1' 7" 1' 0-
3/8
" 1' 7-
7/8
"6-
15/16
"7-
7/8
" 1' 10-
1/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (483) (314) (505) (176) (200) (560) (533) (838) (737)
Notes:
1. To permit blower shaft replacement, the side opposite the controls should have clearance equal to the unit width.
2. Minimum of 3’ for serviceability clearance.
Inlet Hood Support (By Others)
• The purpose of hood support is to
support the weight of the unit
accessories which are attached to the
inlet of the basic unit.
• The hood support can be made from
two, 2” x 2” x ¼” angle iron.
• One angle iron support should be
located in, or close to, the outer
corners of the hood. The supports can
be bolted to the hood.
• The bottom of the angle iron support
should be fitted with a base. The base
can sit on the roof and does not have
to be fixed to the roof. An isolation
pad may be put between the base
and the roof.
Item Unit Components
1 Centrifugal Supply Fan
2 Fan Motor
3 Heat Source (Line Burner)
4 Control Cabinet
5 Hinged Control Cabinet Access Door
6 Motor and Drive Access Plate
7 Access Door
8 Removable Suspension Lifting Lug
9 Manifold Compartment
10 Observation Port
11 Unit Base
Horizontal Arrangement — Single Blower
With Mixing Box
109 112 115 118