Filter
Top Products
19MUA-PRC001-EN
Dimension and
Weights
Inlet Hood Support (By Others)
• The purpose of hood support is to
support the weight of the unit
accessories which are attached to the
inlet of the basic unit.
• The hood support can be made from
two, 2” x 2” x ¼” angle iron.
• One angle iron support should be
located in, or close to, the outer
corners of the hood. The supports can
be bolted to the hood.
Table DW-1
Model A B C E F G H L M R S T
109 3' 0" 4' 4" 6' 5" 10-
3/8
" 1' 3-
1/8
" 1' 2-
7/16
"11-
11/16
" 1' 2-½" 11-
15/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (264) (384) (367) (297) (368) (303) (533) (838) (737)
112 3' 0" 4' 4" 6' 5" 1' 1-
9/16
"1' 1-
9/16
"1' 2-
7/16
"11-
11/16
" 1' 0-
5/8
"1' 3-
15/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (344) (344) (367) (297) (321) (405) (533) (838) (737)
115 3' 0" 4' 4" 6' 5" 1' 4" 1' 0-
3/8
" 1' 7-
7/8
"6-
15/16
"11-
1/8
" 1' 6-
15/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (406) (314) (505) (176) (283) (481) (533) (838) (737)
118 3' 0" 4' 4" 6' 5" 1' 7" 1' 0-
3/8
" 1' 7-
7/8
"6-
15/16
"7-
7/8
" 1' 10-
1/16
" 1' 9" 2' 9" 2' 5"
(914) (1321) (1956) (483) (314) (505) (176) (200) (560) (533) (838) (737)
Notes:
1. To permit blower shaft replacement, the side opposite the controls should have clearance equal to the unit width.
2. Minimum of 3’ for serviceability clearance.
• The bottom of the angle iron support
should be fitted with a base. The base
can sit on the roof and does not have
to be fixed to the roof. An isolation pad
may be put between the base and the
roof.
Horizontal Arrangement — Single Blower
109 112 115 118
Item Unit Components
1 Centrifugal Supply Fan
2 Fan Motor
3 Heat Source (Line Burner)
4 Control Cabinet
5 Hinged Control Cabinet Access Door
6 Motor and Drive Access Plate
7 Access Door
8 Removable Suspension Lifting Lug
9 Manifold Compartment
10 Observation Port
11 Unit Base