Filter
Top Products
– 159 –
Cord holder Fan motor lead wire
Various sensor
lead wires
Reactor
Partition board Reactor
Electric parts box Reactor
No.
11
Part name
Reactor
Procedure
1) Perform works of items to .
NOTE)
The same two reactors are installed to this
outdoor unit though each installation place
is different.
One is attached to a partition board, and the
other is attached to an electric parts box.
2) Remove the connector of the reactor lead
wire connected to the inverter assembly.
3) Remove fixing screws of the reactor.
<Cautions for assembling>
The temperature of the reactor becomes
high during operation of the outdoor unit.
Using a cord holder, fix various sensor lead
wires or fan motor lead wires in the sur-
roundings of the reactor to be fixed to the
electric parts box as shown below so that
they do not come to contact with the reac-
tor.
Remarks