Filter
Top Products
– 92 –
TC sensor
Louver moter
connector
Fan motor
connector
Push the
drain pan
Pull the display
unit toward you
Fixing screw
TC sensor
TCJ sensor
Louver moter
connector
Fan motor
connector
Push the
drain pan
Pull the display
unit toward you
Make absolutely sure that
the leads form a loop
Lead wire cover
Earth screw
Earth screw
TC sensor
TCJ sensor
Lead wire cover
Earth screw
Earth screw
TC sensor
TCJ sensor
No.
Part name
Electric parts
box assembly
Procedures
1) Follow the procedure up to 4) in
above.
2) Remove screw of earth lead attached to
the end plate of the evaporator.
3) Remove the lead wire cover, and remove
connector (5P) for the fan motor and
connector (5P) for the louver motor from
the electric parts box assembly.
4) Pull out TC and TCJ sensors from sensor
holder of the evaporator.
5) Disengage the two claws at the top of the
display unit.
(They can be easily disengaged by
pushing the drain pan above the claws
and at the same time pulling the display
unit toward you.)
6) Remove the fixing screw that secures the
electric parts box assembly, and remove
the assembly.
Remarks
<How to assemble the electric parts box>
1) Hook the top part of the electric parts box
assembly onto the claws on the back
body, and secure it using the fixing screw.
Now attach the display unit.
Connect the connectors for the fan motor
and louver motor.
2) Secure the grounding wire using the fixing
screw.
Insert the TC and TCJ sensors into the
sensor holder.
* Be absolutely sure to loop the grounding
wire, TC and TCJ sensor leads once at
the bottom.