Filter
Top Products
Optional Hardware and Software Model GFC7001E Carbon Dioxide Analyzer
Teledyne Analytical Instruments 61
5. OPTIONAL HARDWARE AND SOFTWARE
This includes a brief description of the hardware and software options available for the GFC 7001E/EM Gas
Filter Correlation Carbon Monoxide Analyzer. For assistance with ordering these options please contact the
Sales department of Teledyne Analytical Instruments at:
TELEDYNE ELECTRONIC TECHNOLOGIES
Analytical Instruments
16830 Chestnut Street
City of Industry, CA 91748
Telephone: (626) 934-1500
Fax: (626) 961-2538
Web: www.teledyne-ai.com
5.1. EXTERNAL PUMPS (OPTIONS 10A-10E, 11, 13)
A variety of optional pumps are available for the GFC 7001E/EM Analyzer. The range of available pump options
meets all typical AC power supply standards while exhibiting the same pneumatic performance.
OPTION
NUMBER
DESCRIPTION
10A External Pump 115V @ 60 Hz
10B External Pump 220V @ 50 Hz
10C External Pump 220V @ 60 Hz
10D External Pump 100V @ 50 Hz
10E External Pump 100V @ 60 Hz
11 Pumpless, external Pump Pack/Rack
13 High Voltage Internal Pump 240V/50Hz
5.2. RACK MOUNT KITS (OPT 20 TO OPT 23)
There are several options for mounting the analyzer in standard 19” racks. The slides are three-part extensions,
one mounts to the rack, one mounts to the analyzer chassis and the middle part remains on the rack slide when
the analyzer is taken out. The analyzer locks into place when fully extended and cannot be pulled out without
pushing two buttons, one on each side.
The rack mount brackets for the analyzer require that you have a support structure in your rack to support the
weight of the analyzer. The brackets cannot carry the full weight of an analyzer and are meant only to fix the
analyzer to the front of a rack, preventing it from sliding out of the rack accidentally.
OPTION NUMBER DESCRIPTION
20A Rack mount brackets with 26 in. chassis slides.
20B Rack mount brackets with 24 in. chassis slides.
21 Rack mount brackets only.
23 Rack Mount for External Pump Pack (No Slides).
Each of these options permits the analyzer to be mounted in a standard 19" x 30" RETMA rack.