Filter
Top Products
Remote Operation Model GFC7001E Carbon Dioxide Analyzer
Teledyne Analytical Instruments 183
To assign or reset the status flag bit assignments, press:
<TST TST> CAL
deletes the
character currently
inside the cursor
brackets.
Press the key repeatedly to cycle
through the available character set:
: Values of can also be set
but are meaningless.
The and
keys move the cursor
brackets “
left and right along the
bit string.
SETUP X.X
ID COM1 COM2 EXIT
SETUP X.X
CFG DAS RNGE PASS CLK EXIT
SETUP X.X
VARS DIAG EXIT
Continue pressing until ...
SETUP X.X
EDIT PRNT EXIT
SETUP X.X
SETUP X.X
PREV NEXT PRNT EXIT
Continue pressing until desired
flag message is displayed
discards the
new setting.
accepts the
new setting.
8.6.8. INSTRUMENT ID CODE
Each instrument on a Hessen Protocol network must have a unique ID code. If more than one GFC 7001E/EM
Analyzer is on the Hessen network, you will have to change this code for all but one of the GFC 7001E/EM
Analyzer’s on the Hessen network (see Section 8.1.6).
The default ID code for the GFC 7001E/EM Analyzers is 300.