Filter
Top Products
36
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Printed in U.S.A. © 2006 by LHP
P/N 700,041M REV. B 11/2006
LHP
1110 West Taft Avenue • Orange, CA 92865
LHP reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distribu-
tor for fi replace code information.
Burner Orifi ce Sizes
Elevation 0-4500 feet ( 0-1372 meters)
Model
Series
Natural
Gas
drill size
(inches)
Propane
Gas
drill size (inches)
SDDV-35
#40 (.098")
*
69L96 •
#53 (.0595")
*
39L10 •
SDDV-40
#36 (.1065")
*
18L40 •
#52
(.0635")
*
LB-55874D •
* Standard size installed at factory
• Part /Cat. Number
Table 14
Figure 62
Note: If the Igniter is damaged, a replacement kit is available - order Catalog Number 87L54.
Figure 61 - Burner Orifi ce
All Models
Step 8. (Refer to Figure 57 on Page 35)
a. Remove the orifi ce from the manifold
and replace it with the one provided in
the kit. See Table 14 for orifi ce sizes
for natural and propane models. Figure
61 illustrates the orifi ce.
b. Retrieve the burner and hold the venturi
tube above the orifi ce . Place the shut-
ter adjusting rod in the propane slot
of the shutter arm (see Figure 55 on
Page 31). Set the burner assembly into
its position and secure the trapezoidal
plate with the two screws previously
removed.
c. Reinstall the baffl e with the two baffl e
securing screws.
Step 9. Reassemble all removed components
by reversing the procedures outlined
in the preceding steps. Use pipe joint
compound or Tefl on tape on all pipe
fi ttings before installing (ensure pro-
pane resistant compounds are used in
propane applications, do not use pipe
joint compounds on fl are fi ttings).
Step 10. Attach the conversion label provided in
the conversion kit to the rating plate on
the appliance.
Step 11.Turn on gas supply and test for gas
leaks.
Pilot Assembly
Igniter Assembly
Retaining Clip
Pilot Orifi ce
Flare Nut