Filter
Top Products
Little Touch & Sew 67A
Table of Contents Previous Page | Next Page
18
How to change the Needle
When your needle becomes blunt or bent,
change it right away. Use only a Catalog No.
2020 (15X1) needle, size 14.
1. Be sure the ON-OFF Power Switch is in
the OFF position.
2. Turn hand wheel until the take-up lever is
raised to its top position.
3. Lower the presser foot.
4. Loosen the screw and pull out the old nee-
dle.
5. Insert a new needle. Make sure the flat
side of needle is toward the back of
machine. Then push it up as far as it will
go and tighten the screw.