Filter
Top Products
Little Touch & Sew 67A
Table of Contents Previous Page | Next Page
13
8. The THROAT PLATE is the working place
for your fabric. The numbered guidelines
to help you sew straight seams.
9. The TENSION DIAL decides how hard
the needle should pull the thread.
10. The TABLE CLAMP holds the machine
tightly to your work table.
11. The BOBBIN WINDER holds the bobbin
when you wind it. Never leave a bobbin
on the winder while you are sewing.
12. The HAND WHEEL moves the take-up
lever and the needle at the same time.
Always follow the arrows when you turn
the hand wheel.
13. The HAND CRANK fits into the slot and
holes of the hand wheel so that you can
work your machine by hand. You must
turn the power switch to OFF before you
use the hand crank. Take the hand crank
out of the hand wheel if you run your
machine by battery or electric power.
A Job For Everything
See how fast you can learn what every part
does.
1. The SPOOL PIN holds the spools of
thread.
2. The TAKE-UP LEVER pulls the thread
from the spool to the needle.
3. The PRESSER FOOT LIFTER raises and
lowers the presser foot.
4. The NEEDLE carries the thread through
the fabric when you sew.
5. The PRESSER FOOT holds the fabric
against the feed dog. (Note: Always put
fabric under the presser foot when you
sew.)
6. The FEED DOG moves the fabric as you
sew.
7. The SLIDE PLATE opens so you can take
the bobbin out. Slide it to the left to open.
Slide it to the right to close.