Filter
Top Products
59
Areas
7
Resetting After an Alarm:
1. Enter your user code. You see
something like this:
AREA 12345
6
678
STATUS RNAHIRAH
In this example, the "6" is
blinking.
2. To clear the system's alarm
memory, press and hold the
[clear mem] key for
2 seconds until you hear two
beeps. Then, press the area
number (or
, to clear
all areas).
Resetting After an Alarm
When an alarm has occurred in
a given area, that area number
in the Area Status Menu blinks.
You can reset the display by
following the instructions to the
right.
Canceling Alarms
In a partitioned system, you can have simultaneous alarms in
several areas. For example, at the same time, alarms may occur
in areas 2, 3, and 5.
To cancel an alarm in an area, press the
key and enter
your user code. You must have rights to an area to cancel an
alarm in that area. If more than one area is in alarm, the keypad
prompts you to repeat the cancellation command for each of the
areas in alarm.