Filter
Top Products
®
®
\
@ ®
®
® ® ®
1. Remove the extension table from
the machine by pulling it to the
left, Open the shuttle cover by pull-
ing down the embossed part on the
left side of the cover,
2. Raise needle to its highest position
by rotating hand wheel toward you.
3. To remove bobbin case from shut-
tle, pull open latch of bobbin case,
4. Pull bobbin case straight out of
shuttle.
5. Insert bobbin into bobbin case
making sure thread is coming from
bobbin as shown.
6- Pull thread through slot of case as
shown.
7. Pull thread under tension spring.
8., Holding latch open, position case
into shuttle, and release latch. Case
should lock into place when latch is
released.