Filter
Top Products
CANISTER
1. Open the canister hood.
2. Check to see that the dust bag is
properly installed. See BAG CHANGING
for instructions.
3. Check to see that the motor safety filter
is properly installed. See MOTOR SAFETY
FILTER CHANGING for instructions.
HOOD AND TOOL STORAGE
COVER
It isnormal for the canister hood and tool
storage cover to come off when opened
further than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and tool storage cover to reinstall.
CAUTION
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canister hood and/or fool storage cover.
This canister is equipped with an on-board
HOSE
1. Line up the
hose latch tab
and notch in
canister hood
and insert hose
into canister until
it snaps into
place.
Latch
Tab
To remove: Do not open hood before
removing hose. With hood closed, lift
hose latch tab upward and pull on hose.
Handle
2. Insert
handle into
wand until
lock button
snaps in
place. Be sure
hose is not
twisted.
Lock
m
Button _ To remove:
Y
Press handle
Handle quick release
Quick button and pull
Release
up on handle.
To store: Disconnect hose form wands and
canister to prevent stress on hose during
storage. Store hose in a loosely coiled
position on the hose covering is not
stressed.
storage area for a Pet PowerMate
attachment.
To install:
Open the Pet PowerMate storage cover.
insert the Pet PowerMate, press down into
place, and close the lid securely.
To Remove:
Open the storage cover. Remove Pet
PowerMate from the storage area and use
as needed (see ATTACHMENTS and
ATTACHMENT USE TABLE).
Pet PowerMate
Storage Cover
=9=