Filter
Top Products
BAG CHANGING
For best cleaning results, the dust bag
should be changed often. The electronic
performance indicator will come on when
the bag needs to be changed or the airflow
is blocked.
NOTE: See PARTSAND FEATURESfor Bag
Number.
1.Turn off and
unplug vacuum
cleaner.
2. Remove hose
from canister.
3. Pull hood
release out and up,
then lift canister
hood.
4. Disengage
cardboard tab from
red bag mount by
pulling away and
lifting up.
Motor
Safety _,
5. Pullbag out of
the red bag
mount.
6. Check the
motor safety filter
and replace, if
necessary.
7.The red bag mount will flip forward after
removing bag. Thiswill prevent the hood
from closing until a new bag is installed.
Note: DO NOT bend or crease the middle
ofthe cardboard when installingthe bag
intothe bag mountslots.
8. Rotate red bag
mount down and
install bag into slots
per illustration,
pushing down until
the cardboard tab
locks intoposition
and the holes align.
9. Tuck the bag securely into the bag
cavity so that none of the bag is able to be
pinched by the hood.
10. Close and latch canister hood.
1|. Inserthose intocanister until it snaps in
place.
12. Plug cord intowall outlet.
CAUTION
NEVER REUSE A DUST BAG. Very fine
materials, such as carpet freshener, face
powder, fine dust, plaster, soot, new car-
pet llnt, etc. can clog the bag and cause it
to burst before it is full and may cause
damage to vacuum cleaner motor.
Change bag more often when vacuuming
these materials.
CLEANING EXTERIOR AND ATTACHMENTS
1.Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. Toclean exterior, or to reduce static
electricity and dust build-up, wipe outer
surfaceof vacuum cleaner and attach-
ments. Use a clean, soft cloth that has
been dipped in a solution of mild liquid
detergent and water, then wrung dry. Wipe
dry after cleaning.
,CAUTION
Do not use attachments if they are wet.
Attachments used in dirty areas, such as
under a refrigerator, should not be used on
other surfaces until they are washed. They
could leave marks.
=17=