Filter
Top Products
5. To replace the
exhaust filter
cover place the
two tabs on the
filter cover into
the slots on the
canister.
_ 4. Replace the
exhaust filter
cartridge. Place
the new filter
into the canister
with the foam
seal towards the
canister.
6. While
holding latch
down rotate
filter cover into
place.
7. Release latch and verify that filter cover
is locked into place.
DIRT SENSOR
Although the dirt sensorfeature inyour
Kenmore canister isdesigned for yearsof
trouble free use,the passage of dirt through
the air passagesystem can coat the lens
causing the green light to come on and stay
on - never switching to red. When this
happens the lensesmust be cleaned.
CAUTION
Never use water or any cleaning solution
when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoating of the lenses and make cleaning
necessary sooner.
TO CLEAN THE LENSES
|. Remove the
handle by
pressing the
handle quick
release button.
Approx.
5 inches
(130 turn)
-_ Sensor
Lenses
2. As indicated by the illustration, the two dirt
sensor lenses are located on the inside of the
handle, approximately 5 inches/]30 mm down
(note the arrows). These lenses should be
cleaned periodically. To reach the sensor
lenses, use a small brush such as a bottle
brush. Brush each sensor lens several times to
remove dust and dirt.
-19-