Filter
Top Products
Regency
®
P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace
30
GLASS DOOR
REMOVAL
1) Remove the 8 screws that secure the glass
door.
INSTALLATION
2) Pull the door slightly out on an angle and
then lift up and pull completely out.
3) P131 & P121LC/P121RC Corner Model:
Remove the 6 screws that secure the glass
door and repeat step 2.
FINISHING TRIM
1) Slide the Side Finishing Trim up into the slot
in the top fl ange of the fi replace. Push tight
against the magnet at the base of the unit.
LOUVERS & GRILLS
1) Attach the screws provided to the top left
and right corners.
NOTE: Do not tighten the screw entirely,
ensure that some room is left to be able to
hang the grill or louver over the screw.
2) Hang the Top Louver or Grill onto the 2
screws in the top fi replace opening.
3) Attach the Bottom Louver or Grill to
the hinges on the bottom fl ange of the
fi replace.
P121-2 & P131-2 Corner Models
4) Attach the screws provided to the top and
bottom, left and right corners similar to
step 1.
5) Hang the top and bottom louver or grill onto
the screws in the top and bottom, left and
right sides of the fi replace opening.
The Top and Bottom Side Louver or Grill is
installed the same way.
2) Slide the Corner Finishing Trim up into the
slot in the top fl ange of the fi replace. Push
tight against the magnet at the base of the
unit.
Slide Trim into
slot.
Push trim tight
against magnet.
Slide Trim into
slot.
Push trim tight
against magnet.