Filter
Top Products
Regency P121-1/P121LC-1/P121RC-1/P131-1 Zero Clearance Direct Vent Gas Fireplace
26
GLASS DOOR
REMOVAL
1) Remove the 8 screws that secure the
glass door.
INSTALLATION
2) Pull the door slightly out on an angle and
then lift up and pull completely out.
3) P131 & P121LC/P121RC Corner Model:
Remove the 6 screws that secure the
glass door and repeat step 2.
FINISHING TRIM
1) Slide the Side Finishing Trim up into the slot
in the top flange of the fireplace. Push tight
against the magnet at the base of the unit.
LOUVERS & GRILLS
1) Attach the screws provided to the top left
and right corners.
NOTE: Do not tighten the screw entirely,
ensure that some room is left to be able
to hang the grill or louver over the screw.
2) Hang the Top Louver or Grill onto the 2
screws in the top fireplace opening.
3) Attach the Bottom Louver or Grill to the
hinges on the bottom flange of the fireplace.
P121-1 & P131-1 Corner Models
4) Attach the screws provided to the top and
bottom, left and right corners similar to step
1.
5) Hang the top and bottom louver or grill onto
the screws in the top and bottom, left and
right sides of the fireplace opening.
The Top and Bottom Side Louver or Grill is
installed the same way.
2) Slide the Corner Finishing Trim up into the
slot in the top flange of the fireplace. Push
tight against the magnet at the base of the
unit.
Slide Trim into
slot.
Push trim tight
against magnet.
Slide Trim into
slot.
Push trim tight
against magnet.