Filter
Top Products
Regency P121-1/P121LC-1/P121RC-1/P131-1 Zero Clearance Direct Vent Gas Fireplace
24
INSTALLATION
LOG INSTALLATION
Read the instructions below carefully and refer to the diagrams.
If logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
The gas log kit (Part # 360-930) contains the following pieces:
a) 02-79 Front Right Log 902-326
b) 02-80 Front Left Log 902-327
c) 02-81 Middle Right Log 902-328
d) 02-82 Middle Left Log 902-329
e) Embers 902-154
The "02" reference numbers (i.e. 02-79) are
molded into the rear of each log.
02-79
02-80
02-82
02-81
Please note that there are 2 of each log. This
log set is mirrored front and back.
02-8102-80 02-82 02-79
02-79
The image below shows all of the logs in place.
Push back side of the left end of the log up
against the tab on the burner.
02-79
02-79
02-80
02-79
02-8202-81 02-80
Grate Post
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Place Log 02-79 on the front right side of the burner. Ensure that the
notches on the far right side of the log fit into the grate posts. Push
back side of the left end of the log up against the tab on the burner.
Repeat step 2 on the opposite side of the burner.
Tab on Burner
3) Place Log 02-80 on the front left side of the burner. Position
the right end of the log in between the two tabs and the left
end of the log into the grate post.