Filter
Top Products
Regency Insert & Hearth Heater 11
Medium Insert I2100M
The unit arrives with the 2 baffle bricks on the
floor of the firebox.
1) If all 3 air tubes are installed continue on to
Step 2), if not, follow the instructions be-
low. Install the air tube into the holes in the
side channels. The notch goes on the right
hand side with the air holes facing toward
the door. Slide the tube into the left hand
side, as far as possible and then bring it
back into the hole on the right hand side until
it locks into position. If the tube will not slide
in easily, simply use a pair of vise grips or
pliers and tap it into place with a hammer.
BRICK FLUE BAFFLE &
SECONDARY AIR TUBE
INSTALLATION
The flue baffle system located in the upper area
of the firebox is removable to make cleaning
your chimney system easier. The brick baffles
must be installed prior to your first fire. Smoke
spillage and draft problems may occur if
the baffles are improperly positioned.
Check the position of the brick baffles on a
regular basis as they can be dislodged if too
much fuel is forced into the firebox.
The Large Insert I3100L is shipped with two of
the secondary air tubes loose inside the fire-
box. They need to be installed after the brick
baffle are installed. Follow the directions be-
low.
Large Insert I3100L
The unit arrives with the first two air tubes
(from the front) and the 2 baffle bricks on the
floor of the firebox. The baffle bricks are
positioned first and then the air tubes are
installed.
NOTE: If the first 2 airtubes are already
installed in the stove, they must
be removed in order to install the
Brick Baffles.
1) Slide the left baffle brick over the two rear
air tubes and then push it all the way to the
left side of the firebox.
Front View
Medium Insert (I2100M)
Large Insert (I3100L)
Small Insert (I1100S)
Hearth Heater (H2100M)
2) Tilt the first Baffle Brick down and then slide
the 2nd Baffle Brick up and back. Reposi-
tion both baffle bricks flat on the air tubes.
3) Important: push both baffle bricks so
they are tight against the side walls.
4) Install the two front air tubes into the holes
on the side channels. The notch goes on
the right hand side with the air holes facing
forward toward the door opening. If the
tube will not slide in easily, simply use a pair
of vise grips or pliers and tap it into place
with a hammer. A tighter fit will ensure the
tube will not move when the unit is burning.
Note: When cleaning the chimney reverse
the above procedures, removing
the air tube and baffle bricks and
then replace them when cleaning
is completed.
INSTALLATION
FLOOR PROTECTION
Please check to ensure that your floor protec-
tion and hearth will meet the standards for
clearance to combustibles. Your hearth ex-
tension must be made from a non-combustible
material.
FIREBRICK ASSEMBLY
Firebrick is included to extend the life of your
insert and radiate heat more evenly. Check to
see that all firebricks are in their correct
positions and have not become misaligned
during shipping.