5100-I ACT WOOD INSERT
R
438-0380E
April 21, 2010
snap disc which will automatically turn the blower on when
the insert reaches this temperature.
blower with the speed control. Figure 27.2.
1. Initial (cold) startup: Leave fan off until your insert is hot
and a good coal bed is established, approximately 30 min-
utes after fuel is lit.
2. High Burn Setting:
burn.
3. Medium or Medium High Burn Setting:
be left off until a good burn is established, then turned on a
medium or high rate.
4. Low Burn Setting:
fan off until the burn is well established; then, if you wish, turn
the fan on at a low rate.
highest fan speed is obtained by turning the rheostat on, then
-
H. Blower Operating Instructions
Figure 27.1
Start-up Air System
up Air Control.
Primary Air System
necessary fresh oxygen to mix with the unburned gases,
helping to create second, third and fourth combustions.
-
G. Air Controls
Primary Air Control
Start-Up Air Control
OPEN - PUSH IN CLOSE - PULL OUT
3NAP$ISC
"Y0ASS3WITCH
"LOWER3PEED
#ONTROL2HEOSTAT
Figure 27.2