Filter
Top Products
5100-I ACT WOOD INSERT
R
438-0380E
April 21, 2010
NOTE: If your home is fairly airtight, it is recommend that
you install the outside air that comes standard with the appli-
NOTE: The replace must have an outside air
supply coming into it in order for the insert outside air
kit to be used.
The grille assembly must be removed before you can
install the outside air. If you plan on moving the blower
cord to the left side of the appliance, do it now while
the grille is removed to save you time. See page 12 for
detailed instructions.
1. Remove the 2 air control spring handles. Figure 11.1.
2. Remove the grille by removing 2 screws in the center of
the grille. Figure 11.2
from the wiring harness. Figure 11.2
4. Remove cover from rear of insert by removing 2 screws.
Figure 11.1
from entering through the front grille. Figure 11.2.
A. Outside Air Installation
Remove 2 screws
Remove both spring handles
Snap disc by-pass switch
Speed control knob
Hole for blower cord
Blower
Figure 11.1
Figure 11.2
CAUTION
• Leaves
• Other debris
WARNING
• Enclosed space such as an attic or garage
• Close proximity to exhaust vents or chimneys
4
Installation Considerations
6.
7.
Re-install grille and spring handles in reverse order.
to close the gap between the panel set and the face of the
Cover from rear of insert is
secured to front of insert