5100-I ACT WOOD INSERT
R
438-0380E
April 21, 2010
2. Second Stage
-
Burn Rate
Air Control. Figure 21.1.
3. Final Stage
It is very important to reload your appliance while enough
lively hot coals remain in order to provide the amount of heat
before
reloading
that the new wood is laid on hot coals.
this we need to learn to burn our stoves in the cleanest way
possible. Doing this will allow us to continue using our wood
stoves for many years to come.
the rear support. Refer to page 28.
NOTE: Remove all labels from glass front prior to lighting
page 31.
is to light easily-ignitable tinder or paper, which ignites the
Heating ue with slightly crumpled newspaper before
adding kindling keeps smoke to a minimum.
D. Building A Fire
3.
Control (center control under ashlip) fully. Figure 23.1
on page 23.
4. Ensure that no matches or other combustibles are in the
can be fatal.
logs 3 inches (76mm) or 4 inches (102mm) in diameter. Be
between them.
7. When ready to reload the insert, add more logs. Large logs
As long as there are hot coals, repeating steps 7 and 8 will
Keep combustible materials, gasoline and other
heater while it is in use.
• Combustible materials may ignite.
•
•
• May generate carbon monoxide if burn material other than
wood.
May result in illness or possible death.
•