Filter
Top Products
C3406M-D (1/07) 17
Camera Adjustments
To perform the following camera adjustments, make sure to plug in the camera and service
connectors. You may have to remove the camera module from the back box.
Connect a monitor. Then turn on power to the camera and monitor. To use the service connector, refer
to
Service Connector
on page 22.
To adjust the DIP switches or the vertical phase, you will need a miniature trimpot adjustment tool
with a 0.05-inch (1.27 mm) blade. Suggested tools include a miniature flat-tip screwdriver, a Philmore
trimpot tool (#63-6808), and the Philmore 10-piece tool set (#63-910).
After you have adjusted the unit, reinstall the camera module into the back box, and install the trim
ring, bubble, and dome liner (if necessary).
NOTES:
•
The electronics of the ICS110-CW automatically adjust the camera to the auto iris. Auto iris
level adjustments are not necessary.
•
The R7 adjustment is reserved.
VARIFOCAL LENS ZOOM AND FOCUS ADJUSTMENTS
To adjust the field of view and the focus:
1. Select a field of view by turning the zoom adjustment ring clockwise/counterclockwise (refer
to Figure 9).
2. Tighten the zoom locking screw.
3. Adjust the focus by moving the focus locking screw clockwise/counterclockwise.
4. Tighten the focus locking screw.
Figure 9.
Location of Zoom and Focus Adjustments
FOCUS
ZOOM