Filter
Top Products
12 C3406M-D (1/07)
5. Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box
to position the conduit plug opposite the notch on the side of the cover. Use the two
8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back
box to the cover.
Figure 4.
404 Plaster Ring Installation
SIDE CONDUIT INSTALLATION
NOTE:
You should install the camera module into the back box before installing the back box into the
cover. When installing the back box into the cover, rotate the camera module to access the mounting
holes. Refer to
Camera Module
on page 14 for more information.
1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the
cover from the back box.
2. Attach the cover to the mounting surface (hardware not supplied). Use stainless steel
hardware when installing the system outdoors.
3. Remove the conduit plug from the side of the back box.
4. Use a blunt tool to pull the wires and plug, located on the base of the back box, into the back
box.
5. Insert the black plug (supplied) into the hole in the base of the back box.
6. Reinstall the back box inside the cover. Line up the conduit plug with the notch on the side of
the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed
earlier) to secure the back box to the cover.
6-32 X 0.75-INCH
OR 8-32 X 0.75-INCH
PHILLIPS PAN
HEAD SCREWS
(SUPPLIED)
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
COVER
BACK BOX
CEILING/
WALL
404 PLASTER RING
(NOT SUPPLIED)