Filter
Top Products
C3406M-D (1/07) 13
7. Install a 0.75-inch (1.91 cm) threaded conduit connector (not supplied) into the conduit hole in
the back box.
Figure 5.
Side Conduit Installation
8. Connect the video cable/wires:
BNC:
Connect the BNC connector from the unit to a mating BNC connector.
Twisted Pair (UTP):
Blue wire = Video +
Gray wire = Video -
9. Connect the power wires.
AC operation only:
If you are wiring more than one Camclosure integrated camera system to
the same transformer, connect one side of the transformer to the red wire on all units, and
connect the other side of the transformer to the black wire on all units. Failure to connect all of
the units the same way will cause the cameras to be out of phase with each other and may
produce a vertical roll when switching between cameras.
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC ~ ~
COVER
0.75-INCH CONDUIT
CONNECTOR
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
BACK BOX
REMOVE
CONDUIT PLUG