Filter
Top Products
8 C603M-A (11/07)
Before You Begin
Endura is a network system that requires a continuous amount of bandwidth to transmit true, live video. Therefore, always include your network
administrator when planning and installing Endura components.
You will also need the following items:
• Pelco-approved Endura certification
• Access to an Endura network
– that is an active, gigabit Ethernet network that supports the full Internet Protocol suite,
– that is configured with at least one Endura system manager, and
– that is configured with at least one Endura workstation.
NOTES:
• Many Endura problems are caused by improper installation practices. For best results, make sure your installation meets the power,
environmental, and networking guidelines described in the Endura Installation Guidelines and Best Practices document (C2670M).
• When using one or more network switches on the Endura network, enable autonegotiation on all switches.
• These network requirements represent the minimum standard for a small Endura-capable security network. Please consult the Endura
Network Design Guide (C1640M) to make sure your network is properly configured. Your system may be different and may require
additional hardware, software, and network resources.
PARTS LIST
Qty Description
1 NET5301T-I video encoder
1 16-pin terminal block
1 2-pin terminal block
1 NET5301T-I Installation manual
1 Safety instructions
1 Pelco badge rotation sticker
4 Rubber feet for desktop installation
NOTE: Since power requirements vary by installation, the NET5301T-I does not include an individual power supply. You can purchase either the
optional NET5301PS single-unit power supply or the RK5100PS-5U rack mount, which includes a power supply. Refer to Connecting Power on
page 25 for more information on supplying power to the NET5301T-I.
USER-SUPPLIED PARTS
In addition to the standard tools and cables required for a video security installation, you will need to provide the following items:
Qty Description
1 Cat5e (or better) cable and connectors for connecting the NET5301T-I to the Endura network
1 Power supply; refer to Connecting Power on page 25 for more information
1 Analog video device (fixed or PTZ camera)
1 Monitor, if using looping video
1 Microphone, if using audio
1 Small flat-tip screwdriver, if connecting camera control, relay, or alarms
You also need to provide all network equipment, such as switches, for the Endura network.