Filter
Top Products
C603M-A (11/07) 17
CONNECTING VIDEO INPUT
The NET5301T-I automatically detects the video standard (PAL or NTSC) and accepts both color and black-white analog video.
To connect video input:
1. Connect a coaxial cable to the camera or other analog video source.
2. Connect the coaxial cable to the video in connector on the rear panel.
3. If not using looping video, enable termination for the NET5301T-I on the Endura workstation. Termination is enabled by default.
The unit supports Coaxitron up-the-coax operation to a PTZ device. When the NET5301T-I receives a camera control command, it transmits that
command up the coaxial cable to the PTZ device. Since Coaxitron is a single-direction protocol, the PTZ device cannot return any data to the unit.
By default, Coaxitron is disabled.
This unit also supports a serial PTZ device that uses the Pelco P or Pelco D protocol, such as the Spectra
®
dome. Connect the coaxial cable from
the device. Then refer to Connecting a PTZ Device (Pelco P/Pelco D) on page 20 to connect the camera control leads.
CONNECTING LOOPING VIDEO
The NET5301T-I supports looping video. It passes the video input to a monitor or other analog video device.
NOTE: Looped video only shows the camera video input. It does not include any behavior graphics.
To use looping video:
1. Connect a coaxial cable to the video out connector on the rear panel.
2. Connect the other end of the coaxial cable to the analog device.
3. Disable termination for the NET5301T-I on the Endura workstation. Termination is enabled
by default.
4. If looping video to additional devices, disable termination on each device. Enable termination on the last device.
NOTE: If you do not terminate the video signal on the last device in the series, ghosting or other imperfections may appear in the video signal.