Filter
Top Products
13.3. Disassembly of Parts
13.3.1. Disassembly of Indoor Unit
13.3.1.1. Removal of the Front Grille
1. Pull the Front Panel up slowly.
Note: Open it by holding up the curve-in on the Grille.
Fig. 1
Fig. 2
2. Remove it inside by pressing Lever Arm with finger.
3. Remove the screw (one) in center part of the unit.
Fig. 3
4. Make the Vertical Louver level (horizontal).
5. Pull up the Screw Caps (2 parts) and remove the screws
(two) inside.
Fig. 4
6. Remove the Top Panel by pressing up the triangle marks (3
points) on it.
Fig. 5
7. Remove the Front Grille by pulling it up with taking notice of
the Chassis Complete and the hooks (four).
Fig. 6
13.3.1.2. Removal of Control Board Box
1. Remove the Front Grille according to the procedure
13.3.1.1.
2. Remove the screws (two) for the interconnect cable holder
and the cable.
3. Remove the screws (two) fixing the Terminal Plate. (The
Terminal Plate will be in the air.)
Fig. 7
Fig. 8
72
CS-HE9DKE CU-HE9DKE / CS-HE12DKE CU-HE12DKE