Filter
Top Products
Sensors: The Crime Guard 850i
4
e security system is equipped with a Glass
Breakage and Dual-Zone Infrasonic Impact Sensor to increase the effectiveness
of the system. The impact sensor is just one in a comprehensive line of available
sensors. Other available options are: piezo shock sensors, and microwave/radar
sensors which can detect objects in motion both inside and outside the vehicle.
• The Crime Guard 850i
4
e control module features dual auxiliary sensor ports,
which easily allows the addition of a further optional sensor.
• If desired, the sensor zone only can be bypassed when the system is armed
with the transmitter or Echo transceiver, but leaving the other protection zones
in place. This feature is convenient when environmental factors, such as hail
or thunder storms, may lead to the system being activated erroneously.
Prewarning Detection Circuit: When the sensor’s prewarn zone is
violated the security system will respond by chirping the siren three times and
relocking all of the doors.* If the prewarn circuit is triggered five times while the
system is armed, the circuit will automatically shutdown until the security system
is disarmed and armed again.
• Prewarning operates from the Infrasonic Impact Sensor only; the Glass
Breakage fully activates the system.
GLASS BREAKAGE & 2-ZONE IMPACT SENSOR
* An optional doorlock interface must be installed
Page 17
THE DOORS WILL LOCK IF
ARMING, UNLOCK IF DISARMING
To Silently Arm or Disarm the System:
Press & Release the “Auxiliary #2 Output” Button ( II ) Twice
THE PARKING LIGHTS
WILL FLASH TWICE IF
ARMING, ONCE IF
DISARMING
Silent Arming and Silent Disarming are both operated by double-pressing the same transmitter button.
Press
2 X
Press
2 X
The transmitter or Echo transceiver can also silently Arm or Disarm the
system. Pressing the “II” button twice simply reverses, or “toggles” the Armed
or Disarmed status that the system is in at the time.
THE SIREN
WILL NOT
CHIRP
SILENT ARMING AND DISARMING
Feature #5 Automatic Rearming
(Factory Default Setting Off)
This feature prevents your system from being disarmed accidentally, config-
uring the system to automatically rearm itself 90 seconds after it has been
Disarmed by the transmitter. The operation of the Automatic Rearming feature
is explained in more detail on pages 12-13.
Programming Automatic Rearming:
Follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will be pressed and
released five times. The system’s response will be five siren chirps, and the Status
Light flashing five times, pausing, then repeating. Within 10 seconds, press and
release the transmitter/transceiver’s "Arm/Lock" button to turn on the Automatic
Rearming feature (the siren will chirp once) or the "Disarm/Unlock" button to
turn the Automatic Rearming feature off (the siren will chirp twice).
Page 32
Feature #6 Auxiliary Output #2 Also Disarms System
(Factory Default Setting On)
This feature configures the Auxiliary Output #2 to automatically Disarm the
system at the same when it is used.
Programming Auxiliary Channel #2 Disarms System:
Follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will be pressed and
released six times. The system’s response will be six siren chirps, and the Status
Light flashing six times, pausing, then repeating. Within 10 seconds, press and
release the transmitter/transceiver’s "Arm/Lock" button to have the system
Disarm when Auxiliary Output #2 is used (the siren will chirp once) or the
"Disarm/Unlock" button to have Auxiliary Output #2 not Disarm the system
when it is used (the siren will chirp twice).
Feature #7 Parking Light Illumination Upon Disarm
(Factory Default Setting On)
This feature configures the system to illuminate the vehicle’s parking and
interior lights for 30 seconds when it is Disarmed. Otherwise, if this feature is
turned off, the parking lights will illuminate only 5 seconds upon Disarming.
Programming Parking Light Illumination Upon Disarm:
Follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will be pressed and
released seven times. The system’s response will be seven siren chirps, and the
Status Light flashing seven times, pausing, then repeating. Within 10 seconds,
press and release the transmitter/transceiver’s "Arm/Lock" button to have the
parking lights turn on for 30 seconds when the system is Disarmed (the siren will
chirp once) or the "Disarm/Unlock" button to have the parking lights on for 5
seconds when the system is Disarmed (the siren will chirp twice).