Filter
Top Products
26
W415-0612 / C / 01.25.08
1. Place the rear log as shown, ensuring the holes on the
underside are placed onto the 2 pins of the log support.
In order to assemble the log set, the glass door must be
removed, see Glass Door Installation and Removal.
FINISHING
GLASS DOOR INSTALLATION AND REMOVAL
LOG PLACEMENT
BRACKET
FIGURE 60a-d
Before the glass door can be removed, the optional front must be removed. The glass door is secured to the top front edge
of the fi rebox and retained by the bottom.
1. Unlatch door
2. Pull handle and rotate 90°.
3. Pivot door slightly and lift out of bottom retainer.
FIGURE 58
90°
2. Place the left log as shown, ensuring the hole on the
underside is placed onto the burner pin. This will rest on the
left side of the rear log.
1. Place the door frame face down careful not
to scratch the paint.
2. Center the gasketed glass inside the door
frame with the thick side of the gasket facing
up.
3. Bend the glass retainers located along the
edge of the door frame over the gasket holding
the glass in place. Careful not to break the
glass.
DOOR GLASS REPLACEMENT
NOTE: Care must be taken when removing and disposing
of any broken glass or damaged components. Be sure to
vacuum up any broken glass from inside the fi replace before
operation.
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINERS
FIGURE 59