Filter
Top Products
7
Arming in Night mode allows you to remain home with all perimeter AND interior protection active--except for the
F-64TPBR Touchpad PIR. If the F-64TPBR Touchpad is located in the bedroom, you may move about the bedroom freely.
1
Check the Touchpad indicators. The green STATUS light must be ON-STEADY, and the LCD dis-
play will read "SYSTEM READY", indicating that the system is ready to arm.
• If the green STATUS light is off and zones are scrolling in the display, a perimeter zone is faulted or a moni-
tored deadbolt is unlocked. Check the open zones listed and close the door, window, or lock the deadbolts
as needed. If you cannot immediately secure the zones or lock the deadbolts, they may be bypassed (see
page 9).
2
Press the NIGHT button.
The Touchpad will voice prompt the correct action.
•
If you change your mind after pressing NIGHT, press RESET to clear arming.
The red ARMED light will light steady and the LCD display will read "ARMED NIGHT", indicating the system is
armed in the Night mode.
To Arm in Night Mode from Stay Mode:
(See page 6 for arming in the Stay mode). When already armed in Stay mode, you can arm in Night
mode from Stay mode by simply pressing the NIGHT button. The green STATUS light will turn on
momentarily, the LCD display will read "ARMED NIGHT" and the red ARMED light will light steady.
NIGHT MODE: ARMING AT NIGHT
SYSTEM READY
"System arming Night
mode"
ARMED
F-64TPBR_OI319A.03_USER_...
page 7
Friday, September 15, 2006 10:39
Composite