Filter
Top Products
Radio Remote Control Programming
Before starting operation of the hand-held radio remote
control, go to Screen 9 of the digital readout screen:
Screen 9
1. Press the button on the radio (wireless)
remote control to turn on the power. Hold down the
RESET switch. The display will now show.
Screen 9
2. After 5 seconds, the display will show:
Screen 9
3. The hand-held remote control module is now ready
for use.
RADIO ADDRESS
NO RADIO
PRESS RESET TO
LEARN A NEW ONE
9
RADIO ADDRESS
NOW SCANNING
FOR NEW
TRANSMITTER
9
RADIO ADDRESS
COMMUNICATING
PRESS RESET TO
LEARN A NEW ONE
9
The remote control cable (Figure 40) has the following
controls:
– Starts and stops the forward pumping.
– Starts pumping in reverse direction.
Connect the remote control cable (Figure 40) to the
receptacle labeled remote located on front of the digital
panel.
Figure 40. Remote Control Cable
Before the remote control cable can be used the pumping
volume rate must be set.
1. Start the pump as outlined in the pumping section of
this manual.
2. Place the pumping control switch in the LOCAL
position.
3. Using the momentary volume control switch, adjust
the pumping rate (volume) to the desired strokes per
minute.
4. Once the desired pumping rate has been acheived,
place the pumping control switch in the REMOTE
position.
REMOTE CONTROL
CABLE UNIT
25 FT. CABLE
PUMP REV
PUMP ON/OFF
TO CONTROL BOX
CONNECTOR
OPERATION